Totally rebuilt 2.5L 4cyl 1991 iron duke motor . .010 over, New oil pump, Pistons , Bearings. Rebuilt head. Never used. Some engine accessories included. Throttle body injection. Over $800.00 invested. Will fit many GM cars 80s-90s.
I believe its a rocket 394 by the D2 code on top of intake see notes below i grabbed off the web and it had a red air cleaner on it..engine turns over freely i just coudlnt get it to pop the carb is frozen up. starter and alternator included, the crossover exhaust cast flange looks good its been in an old car sitting for years oil pan is not rusted it was up off the ground , water pump and alt ...
FOR SALE O.E.M ORIGINAL USED FAN MOTOR AND BLOWER CAGE OUT OF A 2000 GMC SONOMA. MAY FIT OTHER GM APPLICATIONS WORKED JUST FINE WHEN I TOOK IT OUT OF A 2000 GMC SONOMA.20.00.. SHIPPING EXTRA CASH OR MONEY ORDER ONLY PLEASE.
All these parts came off a 2002 Dodge 4.7. Tried to bring the old motor back to life so some of these parts are almost new. I put a different motor in the truck and have these to sell.Good rust free fuel rail with new injectors only about 700 miles on them and injector locks $130.00Timing chain set with 700 miles on them $75.00Oil pump with 700 miles on it $50.00Coils $40.00 for allExhaust mani...
Cj jeep motor, 6 cylinder, 23,000 miles on motor. Ran good, comes with carb, exhaust, ignition, etc. 975.00. Also have auto trans and transfer case available to buy.
FOR SALE O.E.M ORIGINAL USED FAN MOTOR AND BLOWER CAGE OUT OF A 2000 GMC SONOMA. MAY FIT OTHER GM APPLICATIONS WORKED JUST FINE WHEN I TOOK IT OUT OF A 2000 GMC SONOMA.20.00.. SHIPPING EXTRA CASH OR MONEY ORDER ONLY PLEASE.
Similar
Parts to Build a rat 1969 triumph rat project has title . Motor and trans are sold. Chevy rear end . $895.00 . I have a Pontiac flat head straight 8 standard trans , I would sell with this $775.00 ALSO , have a front cross member and several rear ends .
Selling my old beater with a heater, 1994 Chevy Silverado 1500, rear wheel drive with the 350 motor, and 220k miles. Last summer I changed the oil, put a new battery in it, put a new exhaust on from the cat back, and did some patching on the flange between the manifold and y-pipe. This winter the transmission started to slip a bit on me and wont shift past 3rd gear unless you rev it way higher ...
I have 2 buckets for a 1965 Comet. I am asking $300.00 . I also have some misc Comet parts for sale, Motor, trannys, rear ends, trim, Cyclone grills, cyclone hub caps.
125,000 miles 350 TBI motor. Got to many projects going on and I work 10 hour days need to get rid of some stuff, I have a 1995 K3500 8 lug chevy pickup that has a bad motor in it so it will need a motor, the bodies real solid on it, frame is clean for being up north and the interior is nice, everything else is good on it, the front bumper alone ran me $900 its a real heavy duty one, rear bumpe...
Up for sale is a set of mopar 1970 906 heads. heads have been shaved done to 75cc combustion chamber. Intake side of the head was shaved so heads will accept any style intake. Heads have been professionally hand ported and assembled. dont have flow s. Brand new SS race valves at the time. along with PAC springs to match the cam.new locks, retainers,springs etc. The camshaft is a custom built Bu...
1976 mopar motor. Heads completely redone, shaved down, hand ported, new guides, new seats new valves. New springs locks and retainers. Brand new Mopar .509 cam. New push rodd. New double roller timing set. Never fired. About 9 to 1 compression. Edelbrock RPM intake. No carb. Heads intake and Rockers need assembly.$1700 firm. I have over $1200 into heads.
$2,500

1979 camao

I have a 1979 camaro up for sale. Floors and trunk have been replaced has new leaf springs, 10 bolt rear with 342 gears with a locker in it. Has polyurethane all the way around subframe and in leaf springs. Has 2 inch drop coil spring in front new shocks all the way around, all bran new brake lines and gas line new calipers and rear brake shoes. Has a th350 trans that was rebuilt with a shift k...
Mud drag race rail 4x4 chassisWell built straightWas recent competitive MDRA chassisSetup for motor mid plateComes with 9 rear housing w axles rear suspension linksCNC Brake master cylinderFront mounted fuel cellKirkey race seat
Parting out a Malibu Maxx with a 3.5 motor. The motor is the only thin not working. This is the same car as the Malibu, except it has a hatch. Parts that are less than 1 year old headlights, plug wires, lower control arms, steering rack, Winterforce tires, idler and tensioner pulleys, belt. Parts that are less than 2 years old O2 sensor, front cat, rear brake rotors, and front pass window regul...
Motor came out of a 1993 Ford F150. 163,000 miles. Ran good in the truck. Complete minus starter and alternator. Wires were cut off before the plug. No computer. Comes with the torque converter. I have had it for a few months but decided the truck I was going to put it in was just to rusty and not worth the hassle. Been garage kept since pulling it. No Texting
1 + ... Next >