99 Chevy with bad frame. Engine 5.3, auto trans, and axles all good. Once truck is stripped you can still get money from junkyard. Truck does run and drive although it has a fuel leak and bad battery. Leather interior but drivers seat is tore up.
Timbren Rear axle suspension enhancement system. Was used on 2016 Ford F-250. Like New ready to bolt on. 8,000 lb capacity. Call .
Hello, I recently bit the bullet and upgraded my Jeep Wrangler softop to all new stuff. I have a nice pair of window frames that are in nice shape..no rust- they were sanded repainted. I think these sell for $75-80 bucks when new I dont think theyll last long once the weather finally warms up and folks start Jeepin again out on the trails and they see the nice shape these are in. Perfect fit-no...
This transmission is from a 2016 Chevrolet Tahoe with just over 20K miles. I will not be using this in my current project. Please use relay. I will respond with a phone number. Thanks for looking
8 foot Meyer snowplow attached to bracket for tractor. Came off of a 2011 John Deere 4520 tractor. This plow does have hydrolic turn, but I have never hooked it up, I just used manual turn with the pin. $600. Please call seven 1 5 seven 4 8 2 seven 6 four between the hours of 8 am and 5 pm monday thru friday. Ask for Shane
It has a rip at the back of were it latches and one of the clips wen folded r gone for some reason. Dont really need this cause no use for it need gone asap. Taking up room I need in garage. Contact if want to make an offer or wanna buy.
I have a 7.36.9 IDI bell housing that mounts to a T-18T-19 transmission and also other transmissions as well. The bell housing body has been cleaned. Also comes with a dust cover as well. $300 obo. Call or text me at .
Up for sale is a set of mopar 1970 906 heads. heads have been shaved done to 75cc combustion chamber. Intake side of the head was shaved so heads will accept any style intake. Heads have been professionally hand ported and assembled. dont have flow s. Brand new SS race valves at the time. along with PAC springs to match the cam.new locks, retainers,springs etc. The camshaft is a custom built Bu...
1976 mopar motor. Heads completely redone, shaved down, hand ported, new guides, new seats new valves. New springs locks and retainers. Brand new Mopar .509 cam. New push rodd. New double roller timing set. Never fired. About 9 to 1 compression. Edelbrock RPM intake. No carb. Heads intake and Rockers need assembly.$1700 firm. I have over $1200 into heads.
Up for sale is a set of rust free Aarms off of my 1987 Monte Carlo SS. I only removed them because I put a set of aftermarket tubular controls on. The bushings and ball joints are in good shape. Will work on any 1978-88 G Body Monte Carlo, Cutlass, Regal, Grand National, Malibu, El Camino, Grand Prix, Stockcar, Racecar, Stock, Race, Streetstock, Street, PureStock, Pure, Wagon, ect.May be able t...
This is a brand new, never installed Bosal Swan neck, hidden hitch still in the box This hitch bolts directly to the frame of an A4 vw or audi chassis. This is a top of the line hitch, tightly tucked under the bumper and gives you the maximum towing capacity for the A4 platform.
Stainless steel snowplowsStraight blade, V-plows Salt spreaders Call me with any questions. thanks, Marty 715-seven90-six777 no texts or emails, please